by support »
Hello,
It's really best to start from a demo bundle. There are constraints and a lot of settings that need to be done right for the thing to work. If you need to integrate Xillybus' IP cores into an existing system, you should basically reverse engineer the setup and make sure all is in place. There is no short checklist of things to do. Keep an eye on constraints and the settings of the AXI ports.
As for the VGA core, it will not work with the ZC706, as the board uses Analog Device's ADV7511 chipset while the VGA output for Zybo and Zedboard is connected directly to the VGA jack (with resistor ladders that function as a primitive, yet working, DAC). So if it's possible to use the VGA core at all, it requires at least some work to get there.
Regards,
Eli
Hello,
It's really best to start from a demo bundle. There are constraints and a lot of settings that need to be done right for the thing to work. If you need to integrate Xillybus' IP cores into an existing system, you should basically reverse engineer the setup and make sure all is in place. There is no short checklist of things to do. Keep an eye on constraints and the settings of the AXI ports.
As for the VGA core, it will not work with the ZC706, as the board uses Analog Device's ADV7511 chipset while the VGA output for Zybo and Zedboard is connected directly to the VGA jack (with resistor ladders that function as a primitive, yet working, DAC). So if it's possible to use the VGA core at all, it requires at least some work to get there.
Regards,
Eli