Xillybus Virtex 5 Implementation

Questions and discussions about the Xillybus IP core and drivers

Xillybus Virtex 5 Implementation

Postby Guest »

Hello,

How can I change the target fpga in the xillybus core ? I use a lx110t device, but the core generated from IP Core factory website was for lx50t. Also, I use ISE 14.5. Is there any work around so that I can use 14.5 for implementing my design ?

Thank you,

Mugundhan
Guest
 

Re: Xillybus Virtex 5 Implementation

Postby support »

Hello,

The Xillybus IP core binary targets an entire FPGA family, rather than a single device, so any core for Virtex 5 is fine. Please refer to section 4.3.3 in the Getting started with the FPGA demo bundle for Xilinx (available at the Documentation section) for how to build the design correctly.

As for using an ISE version different than ISE 13.1, section 4.3.3 also suggests how to get around that. You'll still have to install ISE 13.1 on your system (there is no need for additional licensing from Xilinx), but you'll be able to implement your design on your version of choice.

Regards,
Eli
support
 
Posts: 802
Joined:


Return to Xillybus