eli wrote:Hello,
The kernel configuration file can be obtained from /boot/config-3.12.0-xillinux-1.3 on Xillinux' file system. Or, alternatively, fetch /proc/config.gz, which contains the configuration of the kernel running (it should be the same on a running Xillinux machnine).
Regards,
Eli
Thank you for replying back. In the config file, I found this line ,
#
# Texas Instruments WL128x FM driver (ST based)
#
CONFIG_RADIO_WL128X=m
Does this mean its enabled by default in your kernel ?
Because the wifi/bluetooth module I am using is from TI, and is numbered, WL1835MODCOM8B, and the document says WLAN and Bluetooth, BLE cores are software and hardware compatible with prior WL127x, WL128x and CC256x offerings, facilitating an easy migration to device.
So if the above kernel option (in quotes) enables the WL128x option, then I can use the wifi/bluetooth modules without any issues. I just have to add a few entries in the device tree for the PMOD ,SDIO and UART0. Right ?