Hello,
We are trying Xillybus PCIe environment on Spartan 6 LXT based system.
We changed demo project a little bit.
- If demoarray[0] equals to 0xFF then fifo32 is written 4 times in a second with dummy data.
In first console we call "streamread \\.\xillybus_read_32" command.
In a different console we write demoarray[0] 0xFF using "memwrite \\.\xillybus_mem_8 0 255" command.
After that the first terminal starts listing received data.
In 64bit Linux system, it works well. But in 64 bit Windows 7, it stops with "Reached read EOF." error message after some transfer between 12 - 250 transfer.
Not immediately after the error but sometimes following error message appears on "Event Viewer"
- xillybus: Failed to quiesce the device on exit.
- xillybus: Quitting while leaving a mess.
How can we solve the problem?
Regards,
Ali